Clicky

Attic Lift FAQ


Q: What are the new features on these SpaceLift models?

A: SpaceLift 5200-S Series attic lifts ship in sections to facilitate ease of moving the components into the attic where they are assembled. 500-lb rated 1/2-inch poly-webbed straps have replaced the aviation-quality steel cables to improve platform stability during operation. The SpaceLift control unit is now built into the motor housing with optional garage wall mount controls available.

Q: How much time is required for installation?

A: With a framed opening and finished attic floor, the component assembly and installation process requires two people, skilled in carpentry and electrical wiring, approximately two to three hours. Read the SpaceLift 5200-S Series Site Selection Guide and Installation Manual for complete specifications.

Q: Does the attic floor need to be finished?

A: Yes. For access, loading and unloading, the top floor must be level and finished with 1/2 to 3/4-inch plywood or comparable material prior to or during the installation process.

Q: What are the joist depth requirements?

A: The SpaceLift 5200-S Series attic lifts feature a unique 7-inch deep low-profile design that fits inside the framed opening. The location - including joist depth, ceiling drywall and attic floor thickness - is to be a minimum of 7 inches to a maximum of 14 inches, measured from the finished ceiling of the lower level to the finished floor of the upper level.

Q: What are the limits on lift travel and ceiling height?

A: The SpaceLift 5200-S Series maximum vertical travel distance is 15 feet from the stowed position to the lower level landing area. The travel limit is set once the ceiling cover is installed.

Q: What happens if the platform load exceeds 200 lbs.?

A. The SpaceLift load management system will detect an overload, the lift will not operate, and both controller arrows will display RED. Turn the key to the OFF position. Lighten the load to less than 200 lbs.; turn the key to the ON position and resume operation.

Q: Does the load need to be balanced on the platform?

A. Yes. Heavy objects are to be placed in the center of the SpaceLift platform. While you may stack modular storage bins and file boxes vertically, place heavier items on the bottom. Check that the lift is stable and not swaying during operation.

Q: What if the lift stops at an inconvenient height?

A. If the lift stops and only the UP arrow is illuminated, the bottom limit can be restored to the Maximum Vertical Travel set during installation (see Install Manual) by following these steps:

  1. Turn remote key to OFF position.
  2. Press and hold BOTH buttons and return key to ON position.
  3. Release both buttons. Arrows will flash RED three times.
  4. Press the UP button to reset the bottom limit.
  5. BOTH arrows will flash RED three times, then the remote will return to normal operating mode.
  6. Press the UP button and return lift to stowed position.

Q: What are the floor load per-square-foot requirements?

A: This depends on the product application and placement in your home. Consult with an architect or structural engineer to confirm local building code requirements.

Q: Do the SpaceLift 5200-S Series attic lifts require an R or fire-rated ceiling hatch?

A: This depends on the product application and placement in your home. Consult with an architect or structural engineer to confirm local building code requirements.

With Built-In Control

With Wall Mount Control

Country Home Elevator & Stair Lift  LLC, Elevators - Sales & Service, Brighton, MO
Visa and Mastercard accepted